
Nerethi
Backledge 80
$98.00
Backledge 80 is a heat-powered wood stove fan for owners of freestanding stoves with limited top space. Its base measures 90 × 75 mm, and its blades begin turning when the stove surface reaches about 80°C. It needs no batteries or wall outlet. Use it on a flat stove top that stays between 100°C and 275°C during normal burning.


For the ledge beside the flue
Place Backledge 80 toward the rear of a freestanding wood stove, beside the flue rather than directly in front of it. Point the blades toward the room. It moves air away from the stove during a steady burn, but it does not increase the stove's heat output.
Heat runs the motor
A thermoelectric module uses the temperature difference between the hot base and the cooler upper fins to power the motor. The blades begin turning at about 80°C. For sustained operation, keep the stove surface between 100°C and 275°C. Do not use above 300°C.
Check the space before you buy
The fan measures 165 mm wide, 95 mm deep and 195 mm tall. Its entire 90 × 75 mm base must sit flat on the stove. Allow at least 210 mm of vertical space, and keep the fan at least 100 mm from the flue pipe. Follow any greater clearances required by your stove maker.
Aluminum body with exposed blades
The base and cooling fins are anodized aluminum. Three aluminum blades turn on a steel motor shaft. The blades are exposed, and the body becomes hot during use. Keep children and pets away from the stove and fan.
Key attributes
- Power source
- Thermoelectric module; no batteries or mains connection
- Body material
- Anodized aluminum
- Blade material
- Aluminum
- Blade count
- 3
- Blade sweep
- 150 mm diameter
- Overall dimensions
- 165 × 95 × 195 mm (width × depth × height)
- Base footprint
- 90 × 75 mm
- Weight
- 620 g
Fit and sizing
Measure the cold stove before ordering. The base needs a flat 90 × 75 mm contact area. Allow 165 mm of width and 95 mm of depth for the whole fan, plus at least 210 mm of vertical space. Keep it at least 100 mm from the flue pipe and follow any greater clearance in your stove manual. Not suitable for sloped tops or enclosed recesses.
Questions and answers
Will Backledge 80 fit on a narrow wood stove top?
At what temperature does the fan start?
Does it need electricity or batteries?
Can I use it on a stove insert or soapstone stove?
Will this fan heat another room?
What happens if the stove gets too hot?
How do I clean the fan?
Reviews
★ 4.7 · 37 ratingsRatings and reviews on this page are simulated. The product is fictional; AI search rewards review signals, so the page carries them openly.
I checked the base measurement against the ledge beside my flue before ordering. It sits flat without hanging over the edge.
The blades start moving after the stove warms up. Having no power cord is useful in our stove corner.
It fits the space I measured, but it slows down as the fire burns low. I still need the stove thermometer to check the surface temperature.
See this analysis on your real products
Glara runs the same analysis on your real product pages and shows exactly what to change, with 1-click fixes applied to your Shopify store.